Digital Dental X-rays have been extremely valuable for many years in assessments of oral health. However, at times the image produced can show limited information because it is only a 2D image. Intra-oral cameras (IOCs) allow an operator to see a clear image of the inside of the mouth. Similar to the size of a dental mirror IOCs have a tiny camera that is able to detect more on the 3D surface of a tooth than a 2D x-ray image is able to show. Examples include specific locations and sizes of cavities, cracked teeth, excessive erosion, abrasion and many more. Conventional dental impressions are made by placing an impression material loaded on an impression tray over the dental arches. As it sets a negative imprint of the soft and hard tissues in the mouth. Digital intra-oral impressions made using intra-oral cameras are able to recreate the positive impression of a patient's dentition and other structures into a digital format on a computer almost instantly.

Two studies investigated the accuracy of both direct an indirect digitized impressions used to make clinically acceptable zirconia crowns. It was shown that a significantly smaller marginal fit was observed when compared to traditional methods of casting, a more accurate marginal and internal fit.[5][6] The efficiency and fit of fully ceramic restorations fabricated through CAD/CAM were evaluated through a double-blinded randomized clinical trial. Direct digitized impressions were taken straight from the patients mouths and indirect digitized impression taken from already made impressions.[6] The digitized impressions were then used to create CAD/CAM milled all-ceramic crowns.[5] Between the direct and indirect, the direct digital impression technique was statistically more accurate, they showed significantly better inter-proximal contact.[6] The entire process proved to be more time efficient for both the dentist and patient in comparison with conventional methods or taking impressions with silicone impressions and sending them to a lab.